Dear all,
I would like to display Safety factor for nodal solution in Ansys Apdl.
I set the value through SALLOW, then I use
SFACT,1
As far as I understand the manual, the PLNSOL should now show the safety
factor yet nothing happens and I still have the stresses.
Am I missing something?
Thank you for support.
Best regards,
Mit freundlichen Grüßen,
M. Eng. Martin Mazurowski
Hauptstrasse 9
D-86637 Wertingen
FON: 08272 9952-29
MOBIL: +49 157 581 577 83
FAX: 08272 9952-99
Mail: mailto:martin.mazurowski@drehmoment.de
martin.mazurowski@drehmoment.de
Web: http://www.drehmoment.de/ www.drehmoment.de
Geschäftsführer:
Dipl.-Ing.(FH) Josef Hofer,
B.Eng. Stefan Zobel,
M.Eng. Martin Mazurowski
Handelsregister Augsburg HRB 21452
Diese E-Mail kann vertrauliche und/oder rechtlich geschuetzte Informationen
enthalten. Wenn Sie nicht der richtige Adressat sind oder diese E-Mail
irrtuemlich erhalten haben, informieren Sie bitte sofort den Absender und
vernichten Sie diese E-Mail. Das unerlaubte Kopieren sowie die unbefugte
Weitergabe dieser E-Mail ist nicht gestattet.
This e-mail may contain confidential and/or privileged information. If you
are not the intended recipient or have received this e-mail in error, please
notify the sender immediately and destroy this e-mail. Any unauthorised
copying, disclosure or distribution of the material in this e-mail is
strictly forbidden.
P Please consider your environmental responsibility before printing this
e-mail.